• video_typing_cover
  • video_typing_cover

i-SPEED 210 and 220 Inputs and Outputs



The 1/0 on a i-SPEED 210 and 220 camera is accessed via a breakout cable that goes in line with the 6 pin power connector.


Trigger in
Recording can be stopped either with a trigger switch or by a low or high external signal

Using a trigger switch
To use a hand trigger cable then connect using BNC T connector with the Trigger In connector on the breakout cable

Using a external trigger input
Connect the Trigger In connector with an external trigger. Enable External Trigger in the Camera 10 menu of the Control 2 series software and decide whether a rising or falling edge of the signal will stop the recording.

Sync in
The Sync In connector allows the user to synchronise one or more cameras with an external signal. Before using this feature, enable Sync In in the Camera 10 menu of the Control 2 Series software and decide whether a rising or falling edge will start synchronisation.

Note : Sync out activates a strobe that corresponds to the exposure time of the camera.
Sync In combined with ARM
Sync In combined with ARM can be used to start/stop recording with a high or low external signal. ARM means that the camera is armed and recording. Enable Sync In in the Camera 10 menu of the Control 2 Series software and decide whether a rising or falling edge will set the ARM signal low or high. ARM is only active if the record settings have been set to Ring Mode in the Control 2 Series software.

Strobe Out
Strobe out supplies the synchronisation, trigger, or recording status of the camera.

Trigger signal widths
The trigger signal is de-bounced. This is why an external mechanical switch can be used. Minimum pulse width according to trigger polarity is shown below.

  • Trigger polarity= rising and a positive pulse of greater than l00nS
  • Trigger polarity= rising and a negative pulse of greater than SmS
  • Trigger polarity= falling and a positive pulse of greater than SmS
  • Trigger polarity= falling and a negative pulse of greater than Sus
Sus after the de bounce the trigger will be processed.
ASK OUR ENGINEERS
0


Back to all technical notes
TAGS
i-SPEED 2
210
220


i-SPEED is a registered trademark of iX Cameras. All rights reserved. Copyright © 2024